The Drummond Geometry Forum

went to the Advanced P&L Manual and realized I would need to do a lot of reading and study even to get to the place where I could decipher those pages.

I would rather just continue my studies with this discs as I don't have a lot time right now to get into the Adv manual.

Could you just point out for me and a brief explanation of the 6/2 6/3 6/4 and I could then just be on my way until I have more opportunity to get into the adv manual.

I have been working with the Psycho-paper, Pattern Picking a little, and the How To manual as well.

The places I found reference to 6/3 are as follows:

Lesson 12 Sec 1 Screens 51 106 107 131

R.S.

Don't bother with anything but 6/1, 6/5 for now.

I have progressed so far to lesson 12 and have noticed in recent lessons sometimes you started using 6/3 up and dn and I always thought that was a typo error for 5/3, but it keeps appearing and I am wondering if this is still a typo error?

L12 Sec1 Scr 104

R.S.

As I recall Charlie threw some of these in though we had dropped them from the set-ups in lesson 2. (We're nothing is not perfectly inconsistent...!). You might have fun reviewing the original thoughts re the 6/1, 6/2, 6/3, 6,4. 6/5 etc etc etc in the Advancd Manual plan 6 rules 1-7 etc, pages 436 ff., from whence the naming convention derives....

Ok to focus on the main 6/1's, 6/5's.... sometimes we got into overkill big-time as we were writing this, piling on more detail than most anyone would ever need....